HBFITES Data Center, Collaboration, Security, Storage, Wireless, Telepresence Training +91-9738931649 info@hbfites.com

CCIE-RS-EE v5.0 - CCIE Route/Switch End-To-End Boot Camp


CCIE Route/Switch End-To-End Boot Camp (CCIE-RS-EE) v5.0 is a 10-day instructor led course with instructor led lessons and hands-on labs. Also, there is troubleshooting on specific topics and assessment labs, including instructor feedback to provide student mentoring and support.

This boot camp is a combination of Narbik's Routing and Switching as well as Cisco 360 CCIE R&S Advanced Workshop.

Course Delivery Method:
This boot camp is approximately 60% lecture and 40% hands-on labs.

The instructor uses a combination of "Chalk talk" and "one on one mentoring", the instructor will NOT use an overhead projector. The instructor uses a traditional method of teaching where the subjects are taught and NOT lectured.

The classroom material and hardware are based on current CCIE Routing and Switching v5 Blueprint.


Boot Camp Hours:
The duration of this boot camp is 10 days, running extended hours most days.
Days 1 thru 4 - 9:00 AM to 9:00 PM or later
Day 5 - 10:00 AM to 4:00 PM
Days 6 & 7 - 10:00 AM to 4:00 PM earlier or later
Day 8 thru 10 - 10:00 AM to 9:00 PM

What the Students Get:

  • Upon registration, the students will receive an E-COPY of "The Foundation 5.0" work book written by Narbik Kocharians to prepare for the Boot Camp. The students should complete the "The Foundation 5.0" work book before attending the boot camp. If you cancel your registration for the class after receiving your e-copy of the "The Foundation 5.0" work book, you will be liable for a minimum of $100.00 for the work book.
  • On the first day of the boot camp the students will receive the following:
    • Cisco's 360 Routing and Switching v.5 Courseware, web portal, and Lab Guide.
    • A secure PDF file of the "Advanced CCIE Routing and Switching 5.0" work book, also written by Narbik Kocharians.
    • A secure PDF file of the "Advanced Troubleshooting 5.0" work book.


Upon completion of this course, learners should be able to perform the necessary and invariant configuration and troubleshooting steps for the following key Cisco CCIE Routing and Switching v5 technologies:

  • Layer 2 Technologies
  • Layer 3 Technologies
  • VPN Technologies
  • Infrastructure Security
  • Infrastructure Services


The knowledge and skills that a learner must have before attending this course are these advanced-level competencies (knowledge and skills):

  • CCNP + certification or equivalent knowledge

It is strongly suggested that the learner had passed the CCIE Routing and Switching written exam.

Who Should Attend

The primary audience for this course is:

  • Candidates that need to acquire their CCIE Routing and Switching certificate.
  • Network engineers/designers that need to raise their knowledge to an expert-level.


Day 1:

  • Lecture:
    • DMVPN (GRE, mGRE, and NHRP)
  • Lab:
    • First Fully graded Assessment Lab (6 Hours) Based on Version 5.0
  • Lecture:
    • Port Security, DHCP Snooping, IP Source-Guard, DAI and ARP ACL, Private VLANs
    • VLAN Access-maps and Storm Control

*Class hours: 9:00 AM to 9:00 PM or later

Day 2:

  • Lecture:
    • OSPF
  • Lab:
    • OSPF Labs
  • Lecture:
    • EIGRP

*Class hours: 9:00 AM to 9:00 PM or later.

Day 3:

  • Lecture:
    • BGP
  • Lab:
    • BGP Labs
  • Lecture:
    • MPLS and L3VPNs

*Class hours: 9:00 AM to 9:00 PM or later.

Day 4:

  • Lecture:
    • QoS - CoS, IP Prec, DSCP mappings, Classification (NBAR), Marking, Policing, Shaping
    • Queuing, CBWRED
    • IPv6 Addressing, SLAAC, DHCPv6, Both, Prefix Delegation, Redundancy using IPv6 RS/RA
    • RA Guard, ND Inspection/Snooping, IPv6 FHRP, IPv6 Filtering, NAT-PT (Static and Dynamic)
    • EIGRPv6, OSPFv3, IPv6 and BGP.
  • Lab:
    • Second Fully graded Assessment Lab which is a combination of two hours of Troubleshooting (30 routers per students emulating the real lab format for Version 5.0), followed by 6 hours of Configuration.

*Class hours: 9:00 AM to 4:00 AM or later.

Day 5:

  • Lecture:
    • Multicasting

*Class hours: 9:00 AM to Noon.

Day 6:

  • Lecture:
    • Route Redistribution
  • Lab:
    • Troubleshooting Mock Lab 1
    • Troubleshooting Multicasting Labs.

*Class hours: 9:00 AM to 6:00 PM or later.

Day 7:

  • Lecture:
    • RIPv2
  • Lab:
    • Configuring RIPv2 Mock lab
    • Configuring EIGRP Mock Lab
    • Troubleshooting Mock Lab 2

*Class hours: 9:00 AM to 6:00 PM or later.

Day 8:

  • Lecture:
    • Cryptography, IPsec VPNs (S2S), VTI, Encrypting Traffic in DMVPN, IPv6 in IPv4 tunnels
    • ACLs, and Time Based ACLs, and uRPF.
  • Lab:
    • Troubleshooting OSPF Lab
    • Troubleshooting BGP Lab
    • Troubleshooting Mock Lab 3

*Class hours: 9:00 AM to 8:00 PM or later.

Day 9:

  • Lecture:
    • NAT, SSH, Conditional Debugging, Object Tracking, Embedded Packet Capture, HSRP, GLBP and VRRP
    • NTP, DHCP, Syslog, Netflow v5 and v9
  • Lab:
    • Troubleshooting MPLS lab
    • Troubleshooting Mock Lab 4

*Class hours: 9:00 AM to 8:00 PM or later.

Day 10:

  • Lecture:
    • Trunks, Ether Channels, BPDU Guard, BPDU Filter, Loop Guard and Root Guard, SPAN, RSPAN, and ERSPAN
  • Lab:
    • Troubleshooting Switching Lab 1
    • Troubleshooting Switching Lab 2

*Class hours: 9:00 AM to 4:00 AM or later.
*Class hours subject to change